Selling Timber in Transylvania County, NC

The office is over the state line in York, South Carolina, but the coverage is squarely western North Carolina: twenty-four counties from the far southwestern mountains through the foothills and into Mecklenburg and Union. Two registered foresters. Appraisal, cruise and sale administration are all there, with prescribed burning, herbicide application, wetland delineation and urban forestry behind them. No association memberships and no website appear in the register.

The map here is the western end of the state: Cherokee, Clay and Graham in the far southwest, up through Asheville and the Blue Ridge to Ashe and Alleghany on the Virginia line, with a foothills tail into Catawba and Cleveland. Twenty-six counties. Nine services, which is a short list — management plans, reforestation, stand improvement, appraisal, cruising, sale administration, and recreation, wildlife and stewardship planning. Prescribed burning and herbicide work do not appear on its register listing.

Mapping is in the firm's name and heads its service list, which matters when a sale is one step in a longer plan for the property rather than a one-off. Thirty-two counties are worked from the Waynesville office: the mountain west, the foothills, and east into the Charlotte piedmont. Appraisal, cruising and sale administration are all on the register entry, so a sale can be carried from valuation through to contract. Ten services in total — a focused list rather than a sprawling one.

A mountain practice with a piedmont tail: thirty-two counties running from Cherokee and Clay in the far southwest, up through the Blue Ridge, out across the foothills and into Mecklenburg and Union. Seventeen services on the register puts it well above the typical listing — appraisal, cruising and sale administration alongside prescribed burning, wetland delineation, forest real estate and stewardship planning. ACF membership marks this as full-time consulting work rather than a sideline, and the Society of American Foresters is listed too.

This is a mountain practice — thirteen counties covering the high country west and north of Asheville, from Buncombe and Haywood out to Madison, Mitchell, Yancey and Avery. The service list runs well past timber. Alongside appraisal, cruising and sale administration, the register credits environmental impact statements, urban forestry, recreation management, forest taxation and stewardship plans. That combination matters when the woods in question sit near a town, a watershed or a permitting question rather than out on open ground. SAF member, with a website listed.

Eighteen services, 43 counties and two registered foresters working out of Asheville, across the mountains, the foothills and the western piedmont — Cherokee and Clay in the far southwest, up through Buncombe and Watauga, and east as far as Guilford and Randolph. The sale package is complete: appraisal, cruise, and administration of the sale itself. Around it sits an unusually wide list — prescribed burning, wetland delineation, forest taxation, forest real estate, herbicide work and urban forestry. ACF and SAF memberships are recorded, along with the International Society of Arboriculture, which fits the urban forestry line.

Western North Carolina, and only western North Carolina: twenty-eight counties from Cherokee and Graham in the far southwest, up through Buncombe and Madison, out to Ashe and Alleghany and down the foothills to Cleveland and Gaston. Fifteen services, an above-average list, and an unusual mix — urban forestry and wetland delineation alongside appraisal, cruising and sale administration. Herbicide application and timber stand improvement are listed too, which is the maintenance side of owning mountain woodland rather than the selling side.

Every county on this list is in the mountains — Buncombe and Henderson west to Cherokee and Graham, north through Madison, Mitchell and Watauga. Appraisal, cruising and sale administration are listed, plus logging engineering, the piece that matters most when getting equipment onto steep ground is half the job. Urban forestry, forest taxation and stewardship plans fill out the entry.

Mountain work, essentially. Twenty-two counties running from Cherokee and Clay in the far southwest across the Blue Ridge to Watauga, Ashe and Wilkes, with a foothill edge in Catawba, McDowell, Polk and Rutherford. Steep ground is its own problem, and the register credits this firm with logging engineering alongside the appraisal, cruising and sale administration a landowner needs to put timber on the market. Fourteen services in total, including forest taxation and recreation management. No website is listed.

This one is not a timber-sale practice. Appraisal, cruising and sale administration are all absent from the register entry. What is listed instead — management plans and mapping, reforestation, stand improvement, logging engineering, Christmas tree management, recreation, urban forestry and stewardship plans — points at growing and tending woodland rather than selling it, across 23 counties covering essentially the whole mountain region, Wilkes and Alleghany west to Cherokee and Clay. It also holds one of the twenty oldest registrations in the state register. A landowner ready to market standing timber should look elsewhere in the directory.

Hiawassee sits just over the Georgia line from Clay County, and from there this firm's register entry covers thirty-two North Carolina counties: the whole mountain west, the foothills, and east across the western piedmont as far as Mecklenburg and Union. Seventeen services puts it near the top of the range on the register — the full appraise, cruise and sell package, then prescribed burning, environmental impact statements, urban forestry, wildlife management and stewardship planning. The office being out of state is the one thing to weigh.

All one hundred counties — one of the few listings on the register that covers the entire state. The registration here is number 8, the second-oldest of the 178 registrations on the register, which is about as long a tenure as North Carolina forestry has to offer. Beyond the sale work of appraisal, cruise and contract administration, this firm surveys, so a boundary question and a timber cruise can be settled on the same visit. Christmas tree management, wetland delineation and environmental impact statements are also listed.

Based over the line in Johnson City, Tennessee, and covering twenty-four counties in the North Carolina mountains — Cherokee, Clay and Graham in the far southwest, up through Buncombe and Madison to Ashe and Alleghany. The register lists five services and no more: management plans, timber appraisal, cruising, sale administration and logging engineering. That is a timber sale specialist's list, and logging engineering earns its place on steep ground. Nothing else is offered, so anything beyond the sale would need another firm.

Fifty-one counties is a great deal of ground for a single registered forester, and the map is essentially the western half of the state: Watauga, Ashe and Yancey in the mountains, the whole piedmont through Charlotte and the Triad, down to Scotland and Richmond. The same firm can look at a mountain hardwood tract and a piedmont pine stand. Appraisal, cruising and sale administration are all listed, with logging engineering, herbicide application and wildlife management around them.

Statewide coverage — all 100 North Carolina counties — from an office in Gainesville, Georgia. Fifteen services are recorded, including the three that make a timber sale work: appraisal, cruising, and sale and contract administration. Prescribed burning, herbicide application, urban forestry and stewardship plans fill out the rest. The register carries this entry under the name US Forest Service, with one N.C. Registered Forester and no website given.

Registration 392 is the tenth-oldest entry on the North Carolina register, about as long a tenure as this directory contains. Coverage runs seventy counties — the entire mountain west, the whole piedmont, and down through the sandhills to the southeastern coast, stopping short only of the northeastern corner. Thirteen services, including appraisal, cruising and sale administration, plus forest taxation, forest real estate and prescribed burning. For a landowner whose sale is tangled up with an estate or a tax question, that last combination is the point.

A mountain-and-foothills practice that reaches east into the Triad: 35 counties, from Ashe, Watauga and Yancey down through Burke and Catawba to Guilford, Randolph and Rockingham. Appraisal, cruising and sale administration are all on the register, so one firm can value the stand, measure it and take the sale through to contract. The rest of the list leans toward what happens to the land afterward — reforestation, stand improvement, prescribed burning, insect and disease protection, recreation and wildlife management, stewardship plans.

Registration 513 sits seventeenth-oldest on the state register, and the firm holds Association of Consulting Foresters membership — ACF admits full-time consultants only, so it signals this is the business rather than a sideline. The office is in Blythewood, South Carolina, but the NC Forest Service register credits sixty-two North Carolina counties: the mountains, effectively the whole piedmont, the sandhills and the southeastern coast. Fourteen services, with appraisal, cruising and sale administration at the center and forest taxation, forest real estate and stewardship planning around them.

Registered in North Carolina, but the office is across the line in Camden, South Carolina. Coverage runs to the far western end of the state — Cherokee, Clay, Graham, Swain — up through Buncombe, then east to the Charlotte piedmont and the Sandhills. Thirty-two counties. Appraisal, cruising and sale administration are all listed, plus logging engineering, which counts on steep ground.

Fifty-one counties, essentially the whole western half of the state: the mountain counties from Ashe and Watauga down through Buncombe and Transylvania, the full piedmont, and the Sandhills edge at Moore and Richmond. Mountain hardwood and piedmont pine are different jobs, and this firm is registered for counties of both. Twelve services, with appraisal, cruising and sale administration among them, plus logging engineering and herbicide application. The office is in Clemmons and a website is on file.

Mecklenburg, Cabarrus, Union, Stanly, Anson — the southern piedmont is the core of this Norwood firm's fourteen-county territory, with a second reach southwest into the foothills at Rutherford, Polk and Transylvania. Thirteen services on the register entry, covering appraisal, cruising and sale administration together with forest taxation, forest real estate, wildlife management and stewardship plans. That is a list aimed as much at the landowner still deciding what to do with a tract as at the one who has already decided to cut.

All 100 counties, which only a handful of firms on the state register can claim — wherever the tract sits in North Carolina, this one covers it. Two registered foresters, and the older of the two registrations is number 482, sixteenth-oldest of the 178 on the register. Appraisal, cruise and sale administration are all here, so a landowner can value the stand, measure it and run the sale through to contract in one place. Seventeen services in all, out as far as Christmas tree management, urban forestry and forest taxation. The firm holds Association of Consulting Foresters membership, which is limited to full-time consultants.

Every county in North Carolina is listed against this firm — all 100 — which puts it in the small group on the register that will work anywhere in the state. The service list is narrow by comparison: ten entries, built tight around the sale itself, with appraisal, cruising and sale and contract administration at the middle and forest taxation, utilization and marketing, urban forestry and stewardship plans around them. Both ACF and SAF memberships are recorded. One registered forester covers that ground, which is worth knowing when you're arranging a visit.

Seven registered foresters is the top of the range on the state register, and it comes attached to eighty-four counties — mountains to the Outer Banks, with very little of North Carolina out of reach. Scale like that means a landowner isn't waiting on one person's calendar, and it means the firm doesn't vanish when someone retires. Nineteen services: wetland delineation, environmental impact statements, forest taxation and urban forestry, alongside the appraisal, cruise and sale-administration combination a competitive timber sale actually runs on. ACF and SAF.

Three generations in, Parton Lumber has changed what it cuts about as often as its markets have: southern yellow pine for post-war housebuilding, Appalachian hardwoods through the furniture years, and eastern white pine today for window and millwork manufacturers. Verno Parton started the company in 1948 and his grandsons Furman and Patrick run it now, with family involvement in lumber traced back to roughly the 1850s. The Rutherfordton operation employs about 130 people, produces some 54 million board feet a year and holds 3.2 million board feet of kiln capacity, selling into export markets as well as domestic ones. It buys standing timber directly and manages its own procurement, so a landowner can sell to the mill without a middleman.

The only confirmation found for this Burnsville outfit is the N.C. Forest Service's Yancey County buyer list, which records it purchasing all hardwood and softwood species as standing timber, sawlogs and pulpwood — a wider brief than the "mixed hardwoods" this listing previously showed. Searches on the company name, the phone number and the Blue Rock Road address returned no website, no Facebook page, no BBB file and no Carolina Loggers Association membership. What the register says is all that can be verified about it.