Selling Timber in Yancey County, NC

Nine counties in the high country north and east of Asheville — Yancey, Mitchell, Avery, Watauga, Ashe, Madison, Buncombe, Haywood and McDowell. Small territory, long list: fifteen services covering appraisal, cruising and sale administration, and then surveying, herbicide application, forest taxation, urban forestry and stewardship plans. A firm that surveys as well as cruises can settle a boundary question on the same visit as the timber.

Mountain work, essentially. Twenty-two counties running from Cherokee and Clay in the far southwest across the Blue Ridge to Watauga, Ashe and Wilkes, with a foothill edge in Catawba, McDowell, Polk and Rutherford. Steep ground is its own problem, and the register credits this firm with logging engineering alongside the appraisal, cruising and sale administration a landowner needs to put timber on the market. Fourteen services in total, including forest taxation and recreation management. No website is listed.

Western North Carolina, and only western North Carolina: twenty-eight counties from Cherokee and Graham in the far southwest, up through Buncombe and Madison, out to Ashe and Alleghany and down the foothills to Cleveland and Gaston. Fifteen services, an above-average list, and an unusual mix — urban forestry and wetland delineation alongside appraisal, cruising and sale administration. Herbicide application and timber stand improvement are listed too, which is the maintenance side of owning mountain woodland rather than the selling side.

Eighteen services, 43 counties and two registered foresters working out of Asheville, across the mountains, the foothills and the western piedmont — Cherokee and Clay in the far southwest, up through Buncombe and Watauga, and east as far as Guilford and Randolph. The sale package is complete: appraisal, cruise, and administration of the sale itself. Around it sits an unusually wide list — prescribed burning, wetland delineation, forest taxation, forest real estate, herbicide work and urban forestry. ACF and SAF memberships are recorded, along with the International Society of Arboriculture, which fits the urban forestry line.

Marshall is the base, and the working radius barely leaves the mountains: nine counties, Buncombe and Madison at the center, out to Swain, Mitchell and McDowell. One of the tightest footprints on the register. The eight listed services are built around a sale — appraisal, cruising, sale and contract administration, stand improvement, forest real estate and herbicide work.

Every county on this list is in the mountains — Buncombe and Henderson west to Cherokee and Graham, north through Madison, Mitchell and Watauga. Appraisal, cruising and sale administration are listed, plus logging engineering, the piece that matters most when getting equipment onto steep ground is half the job. Urban forestry, forest taxation and stewardship plans fill out the entry.

Based over the line in Johnson City, Tennessee, and covering twenty-four counties in the North Carolina mountains — Cherokee, Clay and Graham in the far southwest, up through Buncombe and Madison to Ashe and Alleghany. The register lists five services and no more: management plans, timber appraisal, cruising, sale administration and logging engineering. That is a timber sale specialist's list, and logging engineering earns its place on steep ground. Nothing else is offered, so anything beyond the sale would need another firm.

A mountain practice with a piedmont tail: thirty-two counties running from Cherokee and Clay in the far southwest, up through the Blue Ridge, out across the foothills and into Mecklenburg and Union. Seventeen services on the register puts it well above the typical listing — appraisal, cruising and sale administration alongside prescribed burning, wetland delineation, forest real estate and stewardship planning. ACF membership marks this as full-time consulting work rather than a sideline, and the Society of American Foresters is listed too.

This is a mountain practice — thirteen counties covering the high country west and north of Asheville, from Buncombe and Haywood out to Madison, Mitchell, Yancey and Avery. The service list runs well past timber. Alongside appraisal, cruising and sale administration, the register credits environmental impact statements, urban forestry, recreation management, forest taxation and stewardship plans. That combination matters when the woods in question sit near a town, a watershed or a permitting question rather than out on open ground. SAF member, with a website listed.

All one hundred counties — one of the few listings on the register that covers the entire state. The registration here is number 8, the second-oldest of the 178 registrations on the register, which is about as long a tenure as North Carolina forestry has to offer. Beyond the sale work of appraisal, cruise and contract administration, this firm surveys, so a boundary question and a timber cruise can be settled on the same visit. Christmas tree management, wetland delineation and environmental impact statements are also listed.

This one is not a timber-sale practice. Appraisal, cruising and sale administration are all absent from the register entry. What is listed instead — management plans and mapping, reforestation, stand improvement, logging engineering, Christmas tree management, recreation, urban forestry and stewardship plans — points at growing and tending woodland rather than selling it, across 23 counties covering essentially the whole mountain region, Wilkes and Alleghany west to Cherokee and Clay. It also holds one of the twenty oldest registrations in the state register. A landowner ready to market standing timber should look elsewhere in the directory.

The map here is the western end of the state: Cherokee, Clay and Graham in the far southwest, up through Asheville and the Blue Ridge to Ashe and Alleghany on the Virginia line, with a foothills tail into Catawba and Cleveland. Twenty-six counties. Nine services, which is a short list — management plans, reforestation, stand improvement, appraisal, cruising, sale administration, and recreation, wildlife and stewardship planning. Prescribed burning and herbicide work do not appear on its register listing.

Mapping is in the firm's name and heads its service list, which matters when a sale is one step in a longer plan for the property rather than a one-off. Thirty-two counties are worked from the Waynesville office: the mountain west, the foothills, and east into the Charlotte piedmont. Appraisal, cruising and sale administration are all on the register entry, so a sale can be carried from valuation through to contract. Ten services in total — a focused list rather than a sprawling one.

The office is over the state line in York, South Carolina, but the coverage is squarely western North Carolina: twenty-four counties from the far southwestern mountains through the foothills and into Mecklenburg and Union. Two registered foresters. Appraisal, cruise and sale administration are all there, with prescribed burning, herbicide application, wetland delineation and urban forestry behind them. No association memberships and no website appear in the register.

A mountain-and-foothills practice that reaches east into the Triad: 35 counties, from Ashe, Watauga and Yancey down through Burke and Catawba to Guilford, Randolph and Rockingham. Appraisal, cruising and sale administration are all on the register, so one firm can value the stand, measure it and take the sale through to contract. The rest of the list leans toward what happens to the land afterward — reforestation, stand improvement, prescribed burning, insect and disease protection, recreation and wildlife management, stewardship plans.

The northern mountains around Ashe, Watauga and Avery, down through the foothills at Burke and Caldwell, then east across the western piedmont to Mecklenburg, Guilford and Rockingham — thirty-four counties in all. Registration 546 is the twenty-fourth oldest of 178, a long time on the state register. Fourteen services, appraisal and cruising and sale administration among them, with forest taxation and forest real estate for the landowner weighing a sale against holding on. ACF and SAF.

Fifty-one counties is a great deal of ground for a single registered forester, and the map is essentially the western half of the state: Watauga, Ashe and Yancey in the mountains, the whole piedmont through Charlotte and the Triad, down to Scotland and Richmond. The same firm can look at a mountain hardwood tract and a piedmont pine stand. Appraisal, cruising and sale administration are all listed, with logging engineering, herbicide application and wildlife management around them.

Registration 392 is the tenth-oldest entry on the North Carolina register, about as long a tenure as this directory contains. Coverage runs seventy counties — the entire mountain west, the whole piedmont, and down through the sandhills to the southeastern coast, stopping short only of the northeastern corner. Thirteen services, including appraisal, cruising and sale administration, plus forest taxation, forest real estate and prescribed burning. For a landowner whose sale is tangled up with an estate or a tax question, that last combination is the point.

The office is over the state line in Rock Hill, South Carolina, but the coverage is anything but local — 48 North Carolina counties, from Union and Mecklenburg up through the Triad and out west as far as Madison, Mitchell and Yancey. Appraisal, cruising and sale administration are all recorded, the set needed to run a competitive sale end to end. ACF membership marks this as full-time consulting work. Twelve services in total; no website on the register.

Fifty-one counties, essentially the whole western half of the state: the mountain counties from Ashe and Watauga down through Buncombe and Transylvania, the full piedmont, and the Sandhills edge at Moore and Richmond. Mountain hardwood and piedmont pine are different jobs, and this firm is registered for counties of both. Twelve services, with appraisal, cruising and sale administration among them, plus logging engineering and herbicide application. The office is in Clemmons and a website is on file.

Hiawassee sits just over the Georgia line from Clay County, and from there this firm's register entry covers thirty-two North Carolina counties: the whole mountain west, the foothills, and east across the western piedmont as far as Mecklenburg and Union. Seventeen services puts it near the top of the range on the register — the full appraise, cruise and sell package, then prescribed burning, environmental impact statements, urban forestry, wildlife management and stewardship planning. The office being out of state is the one thing to weigh.

Registration 513 sits seventeenth-oldest on the state register, and the firm holds Association of Consulting Foresters membership — ACF admits full-time consultants only, so it signals this is the business rather than a sideline. The office is in Blythewood, South Carolina, but the NC Forest Service register credits sixty-two North Carolina counties: the mountains, effectively the whole piedmont, the sandhills and the southeastern coast. Fourteen services, with appraisal, cruising and sale administration at the center and forest taxation, forest real estate and stewardship planning around them.

All 100 counties, which only a handful of firms on the state register can claim — wherever the tract sits in North Carolina, this one covers it. Two registered foresters, and the older of the two registrations is number 482, sixteenth-oldest of the 178 on the register. Appraisal, cruise and sale administration are all here, so a landowner can value the stand, measure it and run the sale through to contract in one place. Seventeen services in all, out as far as Christmas tree management, urban forestry and forest taxation. The firm holds Association of Consulting Foresters membership, which is limited to full-time consultants.

Statewide coverage — all 100 North Carolina counties — from an office in Gainesville, Georgia. Fifteen services are recorded, including the three that make a timber sale work: appraisal, cruising, and sale and contract administration. Prescribed burning, herbicide application, urban forestry and stewardship plans fill out the rest. The register carries this entry under the name US Forest Service, with one N.C. Registered Forester and no website given.

Ninety-two of North Carolina's hundred counties, and the eight it leaves out are all in the far southwestern mountains — Cherokee, Graham, Swain and their neighbors. Everywhere else in the state is on the list, which makes this one of the widest footprints on the register. The office, though, is in Columbia, South Carolina: registered to work here, but based over the line. Appraisal, cruise and sale administration are all listed, alongside prescribed burning, forest taxation, forest real estate and stewardship plans.

Registered in North Carolina, but the office is across the line in Camden, South Carolina. Coverage runs to the far western end of the state — Cherokee, Clay, Graham, Swain — up through Buncombe, then east to the Charlotte piedmont and the Sandhills. Thirty-two counties. Appraisal, cruising and sale administration are all listed, plus logging engineering, which counts on steep ground.

Mountain work, and only mountain work: eight counties running from Ashe and Watauga in the northwest southwest to Swain and Haywood, every one of them high-country. Seven services appear on the register, and three of them are the ones a sale turns on — appraisal, cruise, and sale and contract administration. Logging engineering is listed too, which counts for something on steep ground. The office itself sits over the state line in Richwood, West Virginia.

Seven registered foresters is the top of the range on the state register, and it comes attached to eighty-four counties — mountains to the Outer Banks, with very little of North Carolina out of reach. Scale like that means a landowner isn't waiting on one person's calendar, and it means the firm doesn't vanish when someone retires. Nineteen services: wetland delineation, environmental impact statements, forest taxation and urban forestry, alongside the appraisal, cruise and sale-administration combination a competitive timber sale actually runs on. ACF and SAF.

Every county in North Carolina is listed against this firm — all 100 — which puts it in the small group on the register that will work anywhere in the state. The service list is narrow by comparison: ten entries, built tight around the sale itself, with appraisal, cruising and sale and contract administration at the middle and forest taxation, utilization and marketing, urban forestry and stewardship plans around them. Both ACF and SAF memberships are recorded. One registered forester covers that ground, which is worth knowing when you're arranging a visit.

Two plants sit behind this listing: the sawmill on Depot Street in Burnsville and a second site in Marion that runs the dry kilns, the planer mill and shipping. The company says it buys its raw material directly from local loggers and landowners, and keeps timber purchasing, forestry and land management and veneer log sales with its own staff, so a landowner selling standing timber deals with the mill itself. Output is green rough lumber in ash, maple, oak, white pine and yellow poplar, and the Primary Forest Products Locator Network lists Bryant & Young as an exporter in the 51-100 employee band, though that record was last updated in 2015. Its resources page points landowners to the NC Forestry Association and the N.C. Forest Service.

The only confirmation found for this Burnsville outfit is the N.C. Forest Service's Yancey County buyer list, which records it purchasing all hardwood and softwood species as standing timber, sawlogs and pulpwood — a wider brief than the "mixed hardwoods" this listing previously showed. Searches on the company name, the phone number and the Blue Rock Road address returned no website, no Facebook page, no BBB file and no Carolina Loggers Association membership. What the register says is all that can be verified about it.

Trading publicly as Parker Lumber, this Burnsville mill has been family owned and operated since 1984 and offers landowners a free timber analysis of their property before any harvest. The company describes its cutting as "very selective" and aimed at the "sustainability of the trees for future harvests", under the tagline Sustainable Harvest. It appears as a sawmill handling both softwood and hardwood on the Primary Forest Products Locator Network, and the BBB records about 20 employees at the US 19E yard. One side line unusual for a timber buyer: bulk landscaping mulch in several colors, sold by the pick-up load. The LLC itself was registered in North Carolina in 2005, converting the earlier Parker Forest Products, Inc.